Description

Fleet ClearFlex, PFS's premier protective clear coat, is an extremely durable, waterborne clear coating. Formulated specifically for fleet and vehicle graphics, this coating minimizes the effects of UV light transmission, oxidation, moisture and temperature, and has an increased resistance to abrasion. Fleet ClearFlex was designed to protect digital prints on vinyl, piezo inkjet prints, electrostatic transfer prints, superwide output, proofs, and signs and banners that use water-resistant inks and substrates. Available in gloss (D316), semigloss (D317), and matte (D318), Fleet ClearFlex can be easily applied by brush, roll, spray, or by automated applicators (i.e.: AquaSeal™ 1000).

UV Protection

Fleet ClearFlex contains both ultraviolet absorbers (UVA's) and hindered amine light stabilizers (HALS) for the maximum in UV light protection. UVA's absorb harmful UV radiation to protect the coating and substrate. HAL's inhibit the breakdown in a coatings binder by means other than absorption. When applied at the recommended thickness, 1 mil DFT, media will be protected from premature fading for up to 3 – 5 years, blocking out 99% of UV transmission.

Print Durability

Fleet ClearFlex protects digitally produced art, namely fleet graphics, truck side graphics, vehicle wraps, and billboards from abrasion, water, and premature fading while maintaining the flexibility of the media. It also "pops" the colors, giving a wet look to the print. While providing the below features, Fleet ClearFlex also maintains a lower cost per square foot in comparison to hard laminates.

VOC

235 g/l - (1.96 lbs./gal.)

Flash Point

167°F

Coverage

400 sq. ft./gal. [theoretical at 1 mil DFT]

Dry Time

1 hr. [60°F at 50% RH and 1 mil DFT]

Advantages

• UV inhibiting
• Non-yellowing
• Abrasion resistant
• Very flexible
• Waterproof
• Fast drying
• DOT non-hazardous
• RF weldable
• Increased abrasion resistance
• Chemical resistant
  

Application

Application of Fleet ClearFlex varies depending on your company's production needs.

Brushing

On smaller projects with fewer prints, brushing the Fleet ClearFlex on with a disposable 4" foam brush or foam paint pad is the best method. Apply slowly with light pressure to avoid bubbling.

Rolling

Use a ¼" close nap roller for the best performance on medium to large surfaces. Always load the applicator with the maximum amount of coating as possible and apply with light pressure to obtain a smooth coat without air bubbles. Vigorous rolling and high pressure may produce trapped bubbles on the surface.

Mopping

For large or extra-large surfaces (i.e.: billboards) mopping the material on with squeegees is a recommended method of application if space allows. This method is fast and will give a smooth, even coat across the entire image.

Spraying

Using conventional air atomization equipment or HVLP spray equipment is a good method for application on outdoor murals, statues, and other three dimensional objects. Fluid tip size should be .045"- .060" at 30 pound atomizing pressure at 9- 12 cfm.

Automated

Fleet ClearFlex may be applied using the AquaSEAL™ laminators.

Always Test Before Production Use.

Order Number and Gloss

D316 Clear UV Gloss
D317 Clear UV Semigloss
D318 Clear UV Matte/Flat

Fleet ClearFlex™

UV Protection for Fleet Graphics