Description

Graffiti Release is an extremely high performance twopart air-dry urethane graffiti resistant coating. This heavy duty solvent based coating offers protection in severe service areas; outdoor murals and signage, chemical exposure, high traffic (graffiti prone) areas, and floor graphics. Graffiti Release, designed for resistance to UV light exposure, chemicals (acids, alkalis, and solvents), moisture, and saltwater spray has excellent hardness providing an almost baked like quality finish. This coating has a reduced gloss (semigloss D460) for better outdoor viewing and a chemical additive that allows for easy removal of graffiti. Brush, roller, or spray equipment may apply it.

UV Protection

Graffiti Release contains both ultraviolet absorbers (UVA's) and hindered amine light stabilizers (HALS) for the maximum in UV light protection. UVA's absorb harmful UV radiation to protect the coating and substrate. HAL's inhibit the breakdown in a coatings binder by means other than absorption. When applied at the recommended thickness, 1 mil DFT, media will be protected from premature fading for up to 3-5 years, blocking out 99% UV transmission.

Print Durability

Graffiti Release was formulated for interior and exterior digital prints, metal, wood, plastic, masonry and graphic arts surfaces. Typically used on business signs, outdoor advertising signs, floor graphics, and sculptures. When applied with a recommended 2 mils minimum DFT and allowed full cure, the coating will provide the advantages listed below.

VOC

335 g/l – (2.8 lbs./gal.) [mixed 3:1]

Flash Point

60° F

Coverage

700 sq. ft./gal. [theoretical at 1 mil DFT]

Dry Time

3 hr. [60°F at 50% RH and 1 mil DFT]

Advantages

• UV inhibiting
• Non-yellowing
• Abrasion resistant
• Very flexible
• Excellent hardness
• Chemical resistant

Application

Graffiti Release is designed primarily for spray application. For proper surface protection and easy removal of the graffiti, enough coating must be applied to seal the surface thoroughly. The substrate will require at least two coats and full cure. On rough surfaces spray application is the most effective method of application, however, on small surfaces, application by brush or roller is possible.

Conventional Spray

.050 fluid tip nozzle, air cap suitable for available air and medium to heavy viscosity paints, 40 psi fluid pressure and 80-100 psi air pressure.

Graffiti Removal

Soiling and/or graffiti are easily cleaned from smooth treated surfaces using commercial cleansers or ordinary lacquer thinner. There is simply no better way to protect an image.

Always Test Before Production Use.

Order Number and Gloss

D460 100% Clear
D460B Hardener

Graffiti Release™

Graffiti Resistant UV Coating